Resistors,the short-circuiting or disconnecting of which would cause an infringement of the requirements for operation under fault conditions and resistors bridging contact gaps of mains switcher,shall have an adequate stable resistance value under o

来源:学生作业帮助网 编辑:六六作业网 时间:2024/12/25 15:00:07
Resistors,theshort-circuitingordisconnectingofwhichwouldcauseaninfringementoftherequirementsforopera

Resistors,the short-circuiting or disconnecting of which would cause an infringement of the requirements for operation under fault conditions and resistors bridging contact gaps of mains switcher,shall have an adequate stable resistance value under o
Resistors,the short-circuiting or disconnecting of which would cause an infringement of the requirements for operation under fault conditions and resistors bridging contact gaps of mains switcher,shall have an adequate stable resistance value under overload.
Such resistors shall be positioned inside the enclosure of the apparatus.
Compliance is checked by test,carried out on a sample of 10 specimens.
For resistor connected between HAZARDOUS LIVE parts and ACCESSIBLE conductive parts(危险带电零部件与可触及导电部件) and for resistors bridging contact gaps of MAINS SWITCHES(电源开关),the 10 specimens are each subjected to 50 discharges at maximum rate of 12/min,from a 1 n F capacitor charged to 10KV in a test circuit as shown in Figure 5a.

Resistors,the short-circuiting or disconnecting of which would cause an infringement of the requirements for operation under fault conditions and resistors bridging contact gaps of mains switcher,shall have an adequate stable resistance value under o
电阻,切断短路或导致的构成侵权的要求和电阻工况下桥故障状态的切换电源接触间隙,应给予充分的电阻值,超负荷工作.下稳定
这种电阻应定位内部圈地的装置.
合规检查测试,进行10样标本.
对电阻之间连接着危险带电部件和易于导电零件(危险带电零部件与可触及导电部件)和接触电阻的缝隙桥接电源开关(电源开关),10试件的每一个受到最大率50排放12 /分钟,从1 n F电容器收费10 KV测试电路在一个如图5所示.

电阻,短路或断开,会导致故障条件下和弥合接触水管差距切换,应具有过载情况下足够的稳定电阻值的电阻,操作要求侵权。
这些电阻应定位设备的外壳内。
符合测试检查,进行了10例样本。
对于危险的带电部分和可触及的导电部件之间的连接电阻(危险带电零部件相关的例句可触及导电率部件)和弥合接触电源开关差距的电阻(电源开关),10例分别受到最高税率为12到50放电/分钟,从1 N F电容...

全部展开

电阻,短路或断开,会导致故障条件下和弥合接触水管差距切换,应具有过载情况下足够的稳定电阻值的电阻,操作要求侵权。
这些电阻应定位设备的外壳内。
符合测试检查,进行了10例样本。
对于危险的带电部分和可触及的导电部件之间的连接电阻(危险带电零部件相关的例句可触及导电率部件)和弥合接触电源开关差距的电阻(电源开关),10例分别受到最高税率为12到50放电/分钟,从1 N F电容器,10KV作为被控在测试电路如图5a所示。

收起