英语翻译翻译内容:该设计的小功率调幅接收机系统要求采用MC1496调幅,载波频率为7.07MHz,调制度可在10%到100%之间调节,输出幅度调节范围宽:发射部分采用C类功放,输出功率100mW;灵敏度50uv;发射
来源：学生作业帮助网 编辑：六六作业网 时间：2024/11/24 06:44:12
英语翻译翻译内容:该设计的小功率调幅接收机系统要求采用MC1496调幅,载波频率为7.07MHz,调制度可在10%到100%之间调节,输出幅度调节范围宽:发射部分采用C类功放,输出功率100mW;灵敏度50uv;发射
英语翻译
翻译内容:该设计的小功率调幅接收机系统要求采用MC1496调幅,载波频率为7.07MHz,调制度可在10%到100%之间调节,输出幅度调节范围宽:发射部分采用C类功放,输出功率100mW;灵敏度50uv;发射距离可达20m;能实现语音与线路声音信号的同时输入.
英语翻译翻译内容:该设计的小功率调幅接收机系统要求采用MC1496调幅,载波频率为7.07MHz,调制度可在10%到100%之间调节,输出幅度调节范围宽:发射部分采用C类功放,输出功率100mW;灵敏度50uv;发射
This design low power amplitude-modulation receiver system request uses the MC1496 amplitude modulation,the carrier frequency is 7.07MHz,the moudulation percentage may in adjust 10% to 100% between,output amplitude adjustment scope wide:Launches partially uses C kind of merit to put,output 100mW; Sensitivity 50uv; The transmission range may reach 20m; Can realize the pronunciation logical circuit sound signal simultaneously the input
我是自己译的，不是机器译哦
This design's low－power amplitude modulation receriver system requires the use of the MC1496 ampitude modulation. The carrier frequency should be 7.07 MHz and the modulation percenta...
全部展开
我是自己译的，不是机器译哦
This design's low－power amplitude modulation receriver system requires the use of the MC1496 ampitude modulation. The carrier frequency should be 7.07 MHz and the modulation percentage should be adjusted from 10% to 100% . Its output amplitude adjustment scope is wide--the launches partially use C kind of power amplifier with the output power of 100mW ,the sensitivity of 50uV and the taransmission range of 20m ; it can realize the simultaneous input of both pronunciation and logical circuit sound signal.
收起
The low power amplitude modulation receiver system of that design requires MC1496 am modulation, frequency is 7.07MHz, the depth can be adjusted from 10% to 100%, and the adjustment scope is wide for ...
全部展开
The low power amplitude modulation receiver system of that design requires MC1496 am modulation, frequency is 7.07MHz, the depth can be adjusted from 10% to 100%, and the adjustment scope is wide for output amplitude. The transmitting component uses the category C amplifier with 100mW output and 50uv sensitivity, transmission range may reach 20 m; it is possible for the input of voice and circuit audio signals simultaneously.
收起