英语翻译IRSXX01UX-G00组装说明一、拆开包装,贴有条型码的一面朝上放置；（拼装时需注意,铝条间连有电线,不可用力拉扯）二、将YF边依图中箭头所示方向进行展开,角度不可大于90度；三、将Y
来源：学生作业帮助网 编辑：六六作业网 时间：2024/12/23 13:50:59
英语翻译IRSXX01UX-G00组装说明一、拆开包装,贴有条型码的一面朝上放置；（拼装时需注意,铝条间连有电线,不可用力拉扯）二、将YF边依图中箭头所示方向进行展开,角度不可大于90度；三、将Y
英语翻译
IRSXX01UX-G00组装说明
一、拆开包装,贴有条型码的一面朝上放置；（拼装时需注意,铝条间连有电线,不可用力拉扯）
二、将YF边依图中箭头所示方向进行展开,角度不可大于
90度；
三、将YS、XS两边一起依图中箭头所示方向进行展开,角度不可大于90度；
四、将XS边依图中箭头所示方向进行展开,角度不可大于90度；
五、拼接外框,依如图方式拧上四个角的固定螺钉,螺钉：M2.5*4.
六、拧上XF、XS两条侧边的M1.6*4螺钉共4PCS;
七、将屏体翻转,贴有条型码的一面朝下放置,屏组装完成；
八、成品USB出线
注：两种仅出线不同,组装方式相同,以上组装均以55寸以下红外为实例
九、接上电脑进行功能测试,详见下图.
英语翻译IRSXX01UX-G00组装说明一、拆开包装,贴有条型码的一面朝上放置；（拼装时需注意,铝条间连有电线,不可用力拉扯）二、将YF边依图中箭头所示方向进行展开,角度不可大于90度；三、将Y
IRSXX01UX-G00 assembly instructions
First, open the packaging, bar code affixed to the side facing upwards; (keep in mind when assembled, aluminum wires between the connection can not pull hard)
Second, the YF side of the figure according to the direction of the arrow to start, the angle is not greater than
90 degrees;
Third, YS, XS by both sides at the direction of the arrow diagram start point of not greater than 90 degrees;
Fourth, the XS side of the figure according to the direction of the arrow to start, the angle is not greater than 90 degrees;
Fifth, stitching frame, according to the four corners of Figure way fixed screw on the screw, screw: M2.5 * 4.
Sixth, screw on the XF, XS two sides of the M1.6 * 4 screws were 4PCS;
Seven, the screen body flip, bar code affixed to the side facing down, the screen assembly completed;
Eight, finished USB outlet
Note: Two different outlet only, assembled in the same way, these are 55-inch assembly as an example the following infrared
September, conduct functional testing connected to the computer, see the figure below.