请教高手国外图纸英文意思1、ALL OUTSIDE DIAMETERS WITHIN THIS LENGTH MUST BE CONCENTRIC WITHIN .010 TIR.2、HOLE MUST BE CONCENTRIC WITH THIS DIAMETER WITHIN .010 TIR FOR A DEPTH OF .12 MIN.3、THREAD GAGE MUST ENTER THREAD RELIEF.
来源:学生作业帮助网 编辑:六六作业网 时间:2024/12/23 14:18:45
请教高手国外图纸英文意思1、ALL OUTSIDE DIAMETERS WITHIN THIS LENGTH MUST BE CONCENTRIC WITHIN .010 TIR.2、HOLE MUST BE CONCENTRIC WITH THIS DIAMETER WITHIN .010 TIR FOR A DEPTH OF .12 MIN.3、THREAD GAGE MUST ENTER THREAD RELIEF.
请教高手国外图纸英文意思
1、ALL OUTSIDE DIAMETERS WITHIN THIS LENGTH MUST BE CONCENTRIC WITHIN .010 TIR.
2、HOLE MUST BE CONCENTRIC WITH THIS DIAMETER WITHIN .010 TIR FOR A DEPTH OF .12 MIN.
3、THREAD GAGE MUST ENTER THREAD RELIEF.
请教高手国外图纸英文意思1、ALL OUTSIDE DIAMETERS WITHIN THIS LENGTH MUST BE CONCENTRIC WITHIN .010 TIR.2、HOLE MUST BE CONCENTRIC WITH THIS DIAMETER WITHIN .010 TIR FOR A DEPTH OF .12 MIN.3、THREAD GAGE MUST ENTER THREAD RELIEF.
1.所有在此长度内的外径必须同心度在0.010内.
2.孔与此直径的同心度必须在0.010内,深度至少为0.12.
3.螺纹规格必须不能留有螺纹间隙.
1、所有外径在这个长度必须同心在。010年国际公路运输。
2,孔必须同心这个直径在。010年对于一个深度的国际公路运输。12分钟。
3、螺纹规必须输入线程救援。
1.所有在此长度内的外径必须同心度在0.010内。
2.孔与此直径的同心度必须在0.010内,深度至少为0.12.
3.螺纹规格必须不能留有螺纹间隙。