要从物理角度观察生活、指导实践、完成学用转化的飞跃、要有亮点、创新点!注意是“初二课题研究”!不要“实验报告”!要自己写的!(ps:好的话我加悬赏!如果有写的好的我把悬赏加到50!
来源:学生作业帮助网 编辑:六六作业网 时间:2024/11/25 05:24:49
要从物理角度观察生活、指导实践、完成学用转化的飞跃、要有亮点、创新点!注意是“初二课题研究”!不要“实验报告”!要自己写的!(ps:好的话我加悬赏!如果有写的好的我把悬赏加到50!
要从物理角度观察生活、指导实践、完成学用转化的飞跃、要有亮点、创新点!注意是“初二课题研究”!不要“实验报告”!要自己写的!(ps:好的话我加悬赏!
如果有写的好的我把悬赏加到50!
要从物理角度观察生活、指导实践、完成学用转化的飞跃、要有亮点、创新点!注意是“初二课题研究”!不要“实验报告”!要自己写的!(ps:好的话我加悬赏!如果有写的好的我把悬赏加到50!
我看你还是自己写,这个提高很快的.
给你点题目参考参考吧!
Problems for the 24th IYPT 2011
Set of references, questions and advices for 24th IYPT by Ilya Martchenko
1. Adhesive tape
Determine the force necessary to remove a piece of adhesive tape from a horizontal surface. Investigate the influence of relevant parameters.
2. Air drying
Table utensils (dishes, cutlery, etc.), after being washed, dry differently. Investigate how the time of drying depends on relevant parameters.
3. Bouncing flame
Place a flame (e.g. from a Bunsen burner) between two charged parallel metal plates. Investigate the motion of the flame.
4. Breaking spaghetti
Find the conditions under which dry spaghetti falling on a hard floor does not break.
5. Car
Build a model car powered by an engine using an elastic air-filled toy-balloon as the energy source. Determine how the distance travelled by the car depends on relevant parameters and maximize the efficiency of the car.
6. Convection
In a container filled with a liquid, heat transport will occur when the bottom of the container is heated and the top surface is cooled. How does the phenomenon change when the container rotates about its vertical axis?
7. Cup drum
A plastic cup is held upside-down and tapped on its base. Investigate the sound produced when the open end of the cup is above, on or below a water surface.
8. Domino amplifier
A row of dominoes falling in sequence after the first is displaced is a well known phenomenon. If a row of "dominoes" gradually increases in height, investigate how the energy transfer takes place and determine any limitations to the size of the dominoes.
9. Escaping powder
When a hot wire is plunged into a beaker of water with powder (e.g. lycopodium) floating on the surface, the powder moves rapidly. Investigate the parameters that alter the speed of movement of the powder.
10. Faraday heaping
When a container filled with small spheres (e.g. mustard seeds) is vibrated vertically with a frequency between 1 – 10 Hz, so called Faraday heaping occurs. Explore this phenomenon.
11. Fingerprints
Fill a glass with a liquid and hold it in your hands. If you look from above at the inner walls of the glass, you will notice that the only thing visible through the walls is a very bright and clear image of patterns on your fingertips. Study and explain this phenomenon.
12. Levitating spinner
A toy consists of a magnetic spinning top and a plate containing magnets (e.g. "Levitron"). The top may levitate above the magnetic plate. Under what conditions can one observe the phenomenon?
13. Light bulb
What is the ratio between the thermal energy and light energy emitted from a small electric bulb depending on the voltage applied to a bulb?
14. Moving cylinder
Place a sheet of paper on a horizontal table and put a cylindrical object (e.g. a pencil) on the paper. Pull the paper out. Observe and investigate the motion of the cylinder until it comes to rest.
15. Slow descent
Design and make a device, using one sheet of A4 80 gram per m2 paper that will take the longest possible time to fall to the ground through a vertical distance of 2.5m. A small amount of glue may be used. Investigate the influence of the relevant parameters.
16. Smoke stream
A glass jar is covered with cellophane. A tightly folded paper tube of length 4-5 cm is inserted hermetically into the jar through the cellophane cover. The tube is oriented horizontally. If one burns the outside end of the tube the dense smoke flows into the jar. Explore this phenomenon.
17. Vikings
According to a legend, Vikings were able to navigate in an ocean even during overcast (dull) weather using tourmaline crystals. Study how it is possible to navigate using a polarizing material. What is the accuracy of the method?
Problems for the 23rd IYPT
July 2010, Vienna, Austria
1. Electromagnetic cannon
A solenoid can be used to fire a small ball. A capacitor is used to energize the solenoid coil. Build a device with a capacitor charged to a maximum 50V. Investigate the relevant parameters and maximize the speed of the ball.
2. Brilliant pattern
Suspend a water drop at the lower end of a vertical pipe. Illuminate the drop using a laser pointer and observe the pattern created on a screen. Study and explain the structure of the pattern.
3. Steel balls
Colliding two large steel balls with a thin sheet of material (e.g. paper) in between may “burn” a hole in the sheet. Investigate this effect for various materials.
4. Soap film
Create a soap film in a circular wire loop. The soap film deforms when a charged body is placed next to it. Investigate how the shape of the soap film depends on the position and nature of the charge.
5. Grid
A plastic grid covers the open end of a cylindrical vessel containing water. The grid is covered and the vesel is turned upside down. What is the maximum size of holes in the grid so that water does not flow out when the cover is removed?
6. Ice
A wire with weights attached to each end is placed across a block of ice. The wire may pass through the ice without cutting it. Investigate the phenomenon.
7. Two flasks
Two similar flasks (one is empty, one contains water) are each connected by flexible pipes to a lower water reservoir. The flasks are heated to 100℃ and this temperature is held for some time. Heating is stopped and as the flasks cool down, water is drawn up the tubes. Investigate and describe in which tube the water goes up faster and in which the final height is greater. How does this effect depend on the time of heating?
8. Liquid light guide
A transparent vessel is filled with a liquid (e.g. water). A jet flows out of the vessel. A light source is placed so that a horizontal beam enters the liquid jet (see picture). Under what conditions does the jet operate like a light guide?
9. Sticky water
When a horizontal cylinder is placed in a vertical steam of water, the stream can follow the cylinder’s circumference along the bottom and continue up the other side before it detaches. Explain this phenomenon and investigate the relevant parameters.
10. Calm surface
When wind blows across a water surface, waves can be observed. If the water is covered by an oil layer, the waves on the water surface will diminish. Investigate the phenomenon.
11. Sand
Dry sand is rather ‘soft’to walk on when compared to damp sand. However sand containing a significant amount of water becomes soft again. Investigate the parameters that affect the softness of sand.
12. Wet towels
When a wet towel is flicked, it may create a cracking sound like a whip. Investigate the effect. Why does a wet towel crack louder than a dry one?
13. Shrieking rod
A metal rod is held between two fingers and hit. Investigate how the sound produced depends on the position of holding and hitting the rod?
14. Magnetic spring
Two magnets are arranged on top of each other such that one of them is fixed and the other one can move vertically. Investigate oscillations of magnet.
15. Paper anemometer
When thin strips of paper are placed in an air flow, a noise may be heard. Investigate how the velocity of the air flow can be deduced from this noise?
16. Rotating spring
A helical spring is rotated about one of its ends around a vertical axis. Investigate the expansion of the spring with and without an additional mass attached to its free end.
17. Kelvin’s dropper
Construct Kelvin’s dropper. Measure the highest voltage it can produce. Investigate its dependence on relevant parameters.
自己从里面选比较有趣的玩吧!
做个试验杜对于自己的提高是很大的.这些不少是给高中生的,但是初中生可以定性的解释也很不错.比如6. Ice
A wire with weights attached to each end is placed across a block of ice. The wire may pass through the ice without cutting it. Investigate the phenomenon.
这题网上有台湾小朋友做的确实很不错,虽然理论不足,但是试验做的和在PRL和Nature上做的本质完全一致.